emersunn
Registered
I have installed X11 on both of my Macs. It runs good on the G4, but on the iBook i cannot get system-xfree86 installed.
Here is the error from fink:
[ibookaphie:~] emersunn% fink install system-xfree86
sudo /sw/bin/fink install system-xfree86
Password:
Reading package info...
Information about 769 packages read in 12 seconds.
pkg system-xfree86 version ###
pkg system-xfree86 version 4.2-1
The following package will be installed or updated:
system-xfree86
dpkg -i /sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb
(Reading database ... 3454 files and directories currently installed.)
Unpacking system-xfree86 (from .../system-xfree86_4.2-1_darwin-powerpc.deb) ...
dpkg: error processing /sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb (--install):
subprocess pre-installation script returned error exit status 1
Errors were encountered while processing:
/sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb
### execution of dpkg failed, exit code 1
Failed: can't install package system-xfree86-4.2-1
What's going on? I didn't even have to install the system-xfree86 placeholder on the G4 desk computer. It was already there!!!!
i just wanna run Dillo & Gimp . . .
Here is the error from fink:
[ibookaphie:~] emersunn% fink install system-xfree86
sudo /sw/bin/fink install system-xfree86
Password:
Reading package info...
Information about 769 packages read in 12 seconds.
pkg system-xfree86 version ###
pkg system-xfree86 version 4.2-1
The following package will be installed or updated:
system-xfree86
dpkg -i /sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb
(Reading database ... 3454 files and directories currently installed.)
Unpacking system-xfree86 (from .../system-xfree86_4.2-1_darwin-powerpc.deb) ...
dpkg: error processing /sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb (--install):
subprocess pre-installation script returned error exit status 1
Errors were encountered while processing:
/sw/fink/dists/stable/main/binary-darwin-powerpc/x11-system/system-xfree86_4.2-1_darwin-powerpc.deb
### execution of dpkg failed, exit code 1
Failed: can't install package system-xfree86-4.2-1
What's going on? I didn't even have to install the system-xfree86 placeholder on the G4 desk computer. It was already there!!!!
i just wanna run Dillo & Gimp . . .